210-010 Online Practice Questions and Answers

A Vblock System is deployed by VCE using Unified Infrastructure Manager (UIM). During implementation, a problem is encountered that requires the configuration to be changed in the underlying element managers.

Which utility will allow the UIM database to resynchronize with the underlying element manager's changed configuration?

A. Service Adoption Utility

B. VMware Migration Manager

C. Configuration Center

D. VCE Vision Compliance Checker

What are two expected results of the VMware vMotion test plan conducted by VCE at the completion of a Vblock System build? (Choose two.)

A. No unexpected errors or faults occur.

B. The secondary VSM takes over from the primary VSM.

C. There will be minimal packet loss during vMotion.

D. Traffic fails over to the redundant port channel each time a port-channel is disabled.

What is the purpose of the EMC VNXe Connection Utility installed on the Vblock System 320 array management server?

A. to perform upgrades

B. to configure the management IP address

C. to provision storage

D. to troubleshoot performance issues

Which two storage connectivity types are associated with block level access? (Choose two.)

A. NFS

B. iSCSI

C. CIFS

D. FCP

What information is displayed when an administrator uses the show vsan membership command on a Cisco MDS switch?

A. information for a specific VSAN

B. membership information for all VSANs

C. membership information for a specified VSAN

D. zone database information for a specific VSAN

An ESXi host connected to a Vblock System 720 storage array requires a new 2 TB LUN.

According to VCE best practice, which type of device must be created to add to the host?

A. 4 member striped meta

B. 4 member concatenated meta

C. 8 member striped meta

D. 8 member concatenated meta

During a Vblock System 320 deployment, the customer wants to disassociate four half-width blades in a single chassis for a future project.

Which tool is used to perform this compute reconfiguration?

A. vSphere

B. CIMC

C. Unisphere

D. UCSM

What is the requirement for adding VLANs to port channels for disjointed Layer 2 networks in a Cisco UCS?

A. VLANs must be explicitly assigned to an uplink.

B. VLANs should not be explicitly assigned to an uplink.

C. VLAN traffic must be allowed to travel over all uplinks.

D. VLANs must be assigned in the 301-400 range.

In a Cisco Nexus 1000V, what is the default number of ports created in a vEthernet port profile?

A. 32

B. 128

C. 256

D. 512

You are adding a new VLAN from the Cisco Nexus 1000V. You use the state enabled command. What is the result of this command?

A. It creates a new VLAN in the Cisco Nexus 1000V.

B. It creates a new VMkernel port in the ESXi host.

C. It creates a new VLAN in the Cisco fabric interconnects.

D. It creates a port group in the vCenter server.