352-011 Online Practice Questions and Answers

Which DCI technology utilizes a "flood and learn" technique to populate the Layer 2 forwarding table?

A. OTV

B. E-VPN

C. VPLS

D. LISP

You are designing a new multisite data center network within the same city. You are using the newest routers that run OSPF and DWDM point-to-point interfaces for site-to-site connectivity. Your primary objective is to use the fastest possible method for interface failure detection. Which method achieves this objective?

A. UDLD

B. Interface event dampening

C. LoS/AIS event faults

D. Fast-hello timers

A multisite data center network runs OSPF and DWDM point-to-point interfaces for site to- site connectivity. Which method to detect interfaces the fastest?

A. interface event dampening

B. LoS/AJS event faults

C. UDLD

D. fast-hello> timers

Which four resources does Cisco Cloud Center provision in an ACL environment? (Choose four)

A. VLAN Pool

B. Contracts

C. End point Group (EPG)

D. VRF

E. Subject/Filters

F. Application Network Profile (ANP)

A customer requests that you determine how much of their remote branch traffic into a central data center is related to a call manager that resides in the data center. Which solution do you recommend?

A. Enable NetFLow on branch routers

B. Enable netFlow on central data center routers

C. Perform SNMP polling of central data center routers

D. Perform SNMP polling of branch routers

E. Create an ACL on the local call manager switch with logging enabled

F. Span traffic from the switch port on the call manager to a data analyzer

Which two statements about AToM are true? (Choose two)

A. It encapsulates Layer 2 frames at the egress PE

B. When using AToM, the IP precedence filed is not copied to the MPLS packet

C. AToM supports connecting different L2 technologies using interworking option

D. The loopback address of the PE router must be either /24 or /32

E. It provides support for L2VPN features on ATM interfaces

Which feature must be part of the network design to wait a predetermined amount of time before notifying the routing protocol of a change in the path in the network?

A. Transmit delay

B. Throttle timer

C. SPF hold time

D. Interface dampening

At which two networks points is route summarization supported? (Choose two)

A. At EIGRP AS boundaries

B. At EIGRP interface boundaries

C. At OSPF virtual-link boundaries

D. At EIGRP are boundaries

E. At OSPF area boundaries

F. At EIGRP stub interface boundaries

Which IEEE standard is commonly used at the data link layer for an access network, in an IoT environment?

A. Wireless Regional Area Network

B. Low-Rate Wireless Network

C. Wireless Local Area Network

D. Broadband wireless metropolitan Network

Which multicast technology provides a large, many-to-many connectivity for a new application while minimizing load on the existing network infrastructure?

A. PIM Sparse Mode

B. Bidirectional PIM

C. Any-Source Multicast

D. Source Specific Multicast