EW0-100 Online Practice Questions and Answers

Unlike VRRP, the Extreme Standby Router Protocol provides redundancy at both the data link and network layers.

A. True

B. False

What is the default value for the RIP routetimeout setting?

A. 30 seconds

B. 60 seconds

C. 120 seconds

D. 180 seconds

What information can you find using the show edp command?

A. VLANs configured on the remote switch.

B. The ports that are disabled on the remote switch.

C. The master port of any load share groups.

D. The speed and duplex settings of the ports connecting the two switches.

Exhibit:

What is the meaning of the following error?

A. An attempt was made to add an untagged VLAN to a port already in use by anotherprotocol VLAN.

B. An attempt was made to add an IP address to port 1 when it was already configuredwith a protocol filter.

C. An attempt was made to create another tagged VLAN for port 1.

D. None of these.

You are taking steps to secure SNMP access to your switches after reviewing CERT Advisory CA-2002-03 on the Extreme Networks web site. Your supervisor instructs you to turn off SNMP access to the switches. How will you do this?

A. Enter the DISABLE SNMP ACCESS command and then reboot the switch.

B. Enter the DISABLE SNMP ACCESS command.

C. Enter the DISABLE SNMP command.

D. Enter the DISABLE SNMP command and then reboot the switch.

OSPF area 10.10.10.10 connects to OSPF area 1.1.1.1. The network has been running for a week without issues. While examining the LSDB of an internal router in area 1.1.1.1, the network administrator sees that there are no Type-1 LSAs for area 10.10.10.10 listed. The network administrator is puzzled. Why does this situation exist?

A. Type-1 LSAs are disabled for area 10.10.10.10.

B. Type-3 LSAs are enabled for area 10.10.10.10.

C. Type-1 LSAs stay within their own area.

D. Type-2 LSAs include the necessary Type-1 LSA information.

What is the maximum recommended number of VLANs for a multinetted port?

A. 2

B. 3

C. 4

D. 5

Two Extreme Networks switches are connected at Layer-2 via a third-party Ethernet switch. What will EDP report on the ports connecting to the third-party switch?

A. Nothing. EDP is only supported between Extreme Networks devices.

B. The switch type and vendor of the third party switch (third party VLAN information isnot supported).

C. The two Extreme switches will appear to be directly connected.

D. None of these.

Which of the following is a predefined protocol filter?

A. RIP

B. IPX_SNAP

C. SNMP

D. None of these.

Which of the following is a predefined protocol filter?

A. HTTP

B. SMTP

C. Appletalk

D. None of these.