EW0-200 Online Practice Questions and Answers

In spanning tree, the designated bridge is the bridge with the:

A. least-cost path to the root bridge

B. highest bridge priority

C. lowest port cost on all ports

D. None of these

Which statement is true?

A. When a bridge is root-bridge all its ports are root ports.

B. When a bridge is root-bridge only one of its ports is root port.

C. When a bridge is root-bridge none of its ports is root port.

D. None of the above

An OSPF router type whose interfaces connect to two or more Autonomous Systems is called:

A. BDR

B. ABR

C. Internal Router

D. None of these

Which of the following can generate route entries for the IP route table to become populated?

A. UDP-forwarding

B. proxy ARP

C. RIP

D. None of these.

How could you verify that MAC address learning is disabled for ports 1 to 8 on a Summit7i switch?

A. Enter the CLI command: show ports 1,8 config detail

B. Enter the CLI command: show ports 1-8 management detail

C. Enter the CLI command: show ports 1,8 statistics detail

D. Enter the CLI command: show ports 1-8 info detail

The RFC 1918 describes the use and benefits of IP address space for private Internets. The following IP address 192.168.260.1/24 can be considered as a valid private IP address.

A. TRUE

B. FALSE

The CLI command to disable poison reverse on an Extreme switch is:

A. disable rip poisonreverse noadvertise

B. disable poisonreverse rip noadvertise

C. disable rip poisonreverse

D. disable poisonreverse rip

How would you stop a scheduled configuration upload from happening? Use the CLI command:

A. cancel configuration upload

B. configuration upload cancel

C. delete configuration upload

D. upload configuration cancel

You are taking steps to secure SNMP access to your switches by turning off SNMP access to the switches. What is the minimum action you need to perform?

A. Enter the CLI Command DISABLE SNMP ACCESS and then reboot the switch.

B. Enter the CLI Command DISABLE SNMP ACCESS

C. Enter the CLI Command DISABLE SNMP

D. Enter the CLI Command DISABLE SNMP and then reboot the switch.

Prior to downloading a new software image to an Extreme switch using the network, you are required to place the software image in a file on a TFTP server that is accessible on the network.

A. TRUE

B. FALSE