EW0-300 Online Practice Questions and Answers

The integrated IS-IS protocol allows for mixing of IP-only,OSI-only, and dual (IP and OSI) routers.

A. True

B. False

Exhibit According to accompanying diagram and ACL configuration it is possible for Host A (10.10.10.100) and Host C (30.30.30.100) to successfully communicate.

A. TRUE

B. FALSE

What are the advantage/s of using integrated IS-IS as a routing protocol?

A. Requires only one routing protocol

B. Few implementation resources are required

C. Low on utilization of CPU memory and network resources

D. All of the above

Which of the following IP destination addresses can be used for multicast streams?

A. 10.1.0.0

B. 226.0.0.1

C. 192.168.10.0

D. 172.18.255.255

The steps for OSPF to begin routing packets are

A. Hello packet exchange + neighbor adjacency ? LSA exchange ? LSDBsynchronization ? OSPF routing table calculation ? OSPF routing

B. LSA exchange ? LSDB synchronization ? Hello packet exchange ? OSPF routing tablecalculation ? OSPF routing

C. Hello packet exchange ? LSA exchange ? LSDB synchronization ? OSPF routing ?OSPF routing table calculation

D. None of these

IGMP v1 supports the leave group message.

A. True

B. False

In general IS-IS allows routing of both IP and OSI packets. What type of Implementation does ExtremeWare support?

A. IP only

B. OSI only

C. Dual

D. None of the above

A switch originally configured as a VRRP back-up switch has the following potential VRRP states Choose all three that apply.

A. Init

B. Back-up

C. Slave

D. Master

The Address Resolution Protocol enables a device to learn a destinations MAC address by using the destinations known IP addresses in the ARP request.

A. TRUE

B. FALSE

Given router interfaces 10.0.0 1.24, 10.10.10.10/24, 192.168.0.1/24 and 192.168.255.254/24 on a Summit 7i switch. What will be the OSPF router ID upon switch reboot, given the following CLI command config ospf routerid automatic?