Refer to the exhibit.

The administrator has presented an HPE 3PAR StoreServer virtual volume to a server. A single virtual volume is seen as two different offline disks on a Windows 2012 R2 server. What must be done to correct the issue?
A. Install HPE 3PAR DSM MPIO and reboot the server.
B. Install the latest HBA driver and reboot the server.
C. Install the MPIO feature and reboot the server.
D. Install 3PAR host explorer and start service.
A system engineer installed HPE Insight Remote Support for an HPE MSA 2042 storage system at a customer's site. The engineer wants to integrate the system in HPE Insight Online to monitor it remotely.
Which information does the engineer need from the customer to do the integration, using the Insight Remote Support GUI with HPE Insight Online? (Choose two.)
A. HPE Passport ID
B. Product number of MSA 2042
C. Service Agreement ID (SAID)
D. HPE Passport password
E. Serial number of MSA 2042
A customer currently utilizing HPE 3PAR StoreServ 7200 is experiencing performance bottlenecks within their SAN storage.
Which cost-effective upsell or cross-sell HPE storage solution will offer significantly more performance and higher capacity to meet their needs and fit within their current infrastructure?
A. HPE 3PAR StoreServ File Controller v3 System
B. HPE 3PAR StoreServ 8440
C. 8-node HPE 3PAR StoreServ 20000 Storage
D. HPE StoreVirtual 3200 Storage
An integrator is validating a design for an HPE 3PAR StoreServ solution. The assessment document shows that there is structured cabling between the rack the array will be installed in and the racks with the SAN switches. The fiber segments between the racks are documented as being 50 micron OM2 and are terminated with SC connectors.
What needs to be considered when validating this design?
A. 3PAR arrays must be directly connected to SAN switches.
B. The SC connectors must be replaced by LC connectors.
C. OM2 Fiber cables are not supported for 8 Gbps.
D. Fiber segments cannot mix OM2 and OM4 cables.
Refer to the exhibit.

A customer complains of poor performance on an HPE MSA 2040 storage array. The storage administrator thinks that the host ports could be limiting factor because only two ports are connected to the SAN fabric. To verify this the administrator wants to use the performance monitor of the MSA system, but has never used this monitor before. The administrator logs on to a HPE MSA 2040 in the lab to get familiar with performance monitoring.
Which value would indicate a host port performance issue?
A. Read Response
B. IOPS
C. B/s
D. Queue Depth
A storage integrator is installing the HPE StoreVirtual Centralized Management Console (CMC) to manage a StoreVirtual VSA cluster. What is the proper procedure to install the console?
A. Download the StoreVirtual CMC installer and start the installation from primary StoreVirtual VSA node.
B. Download the CMC Appliance and deploy to a hypervisor not running StoreVirtual VSA nodes.
C. Download the StoreVirtual CMC installer and run on the computer with a supported Linux operating system.
D. Download the CMC Appliance and deploy to hypervisors running StoreVirtual VSA nodes.
When is write throttling of HDDs invoked?
A. to synchronize speed of writing to multiple solid-state drives combined with rotational drives
B. to synchronize speed of writing to multiple solid-state drives
C. when drive wearing rate will cause the drive to fail before the warrantied time
D. when the power consumption of a drive exceeds the power cap
In which areas in SSMC can a 3PAR virtual domain membership be selected? (Choose two.)
A. iSCSI port
B. Host
C. Fibre Channel port
D. StoreServ report
E. Common Provisioning Group
A storage integrator is handing over an installed HPE 3PAR storage system to a customer. The customer wants the original license key of the system for setlicense command that is used to prevent the system from prompting for confirmation of new license key.
Which of the following command shows original license key?
A. showlicense -raw
B. displaylicense
C. licshow
D. licenseshow
A customer has 10 different branch offices. Each branch has one MSA 1040 and a StoreOnce 3100. The customer has concerns regarding the actual and predictive failures on sites which don't have any IT staff. Which HPE tool should the integrator implement to provide visibility and alerts for the end customer and HPE?
A. HPE STATS
B. HPE OneView
C. HPE Insight Support Online
D. HPE Insight Remote Support