NS0-184 Online Practice Questions and Answers

You need to install a cluster with a FAS2720 HA pair and a FAS8300 HA pair.

Which NetApp tool will verify which cluster interconnect switches support this configuration?

A. Active IQ Config Advisor

B. Interoperability Matrix Tool (IMT)

C. Hardware Universe (HWU)

D. mysupport.netapp.com site

When you install a new ONTAP 9.7 4-node cluster, which network type is required?

A. data network

B. peering network

C. cluster interconnect

D. intercluster network

You are installing a new ONTAP 9.7 cluster by following the installation and setup poster. You are ready to complete the initial cluster setup. You have connected your laptop to the management switch. However, when browsing the network, you are unable to discover the ONTAP controllers.

Which statement explains this behavior?

A. You do not have network discovery enabled.

B. You do not have a static IP address.

C. You do not have IPv6 configuration set.

D. You do not have a default gateway set.

Your customer wants a newly installed AFF C190 cluster to send SNMP notifications to a trap host called OVERWATCH01.

In this scenario, which two statements are correct? (Choose two.)

A. Configure an SNMP community string on the cluster.

B. Configure DNS on the cluster.

C. Configure a trap host on the cluster.

D. Configure a firewall policy and allow SNMP.

You are setting up a new AFF A400 that will serve iSCSI LUNs. You will have four iSCSI SVMs that each need to connect to an Internet Storage Name Service (iSNS) for discovery and management purposes.

In this scenario, which network interface is needed for each SVM to register with the name service?

A. SVM data LIF

B. SVM management LIF

C. node management LIF

D. intercluster LIF

One of the nodes in your ONTAP 9.7 cluster has failed and is not coming back online.

Which two methods would you use to connect to the node failing to come back online? (Choose two.)

A. Use the Intelligent Platform Management Interface.

B. Use the Service Processor Interface.

C. Use Secure Shell.

D. Use Telnet.

You installed a new pair of Cisco 92300YC cluster switches at a customer's site. Before you install any files on the switch, you want to view the current configuration.

In this scenario, which command would you use to accomplish this task?

A. switchcfgshow

B. fabricshow

C. config show

D. show running-config

Click the Exhibit button.

You want to add a FAS2750 HA pair to an existing 6-node cluster.

Referring to the exhibit, which action would you perform to begin adding the node?

A. Use the back command to begin the Cluster Setup wizard.

B. Reboot the node and enter maintenance mode and run the Cluster Setup wizard.

C. Use the node setup wizard and select 0a as the management interface.

D. Use the exit or quit commands then run the cluster setup command.

You install a 4-node cluster with an AFF A400 HA pair and a FAS8300 HA pair. After setup, you are asked to review the audit logs on each controller from a Web browser.

In this scenario, which method provides access to the logs from a Web browser?

A. ACP

B. ADP

C. DNS

D. SPI

You have an AFF All SAN Array (ASA) cluster that is running ONTAP 9.7. The cluster is configured for Active Directory domain controller access using a domain tunnel.

In this scenario, which two licenses are enabled on the cluster? (Choose two.)

A. iSCSI

B. CIFS

C. NVMe

D. FCP