NSE5_FAZ-6.2 Online Practice Questions and Answers

Which statements are correct regarding FortiAnalyzer reports? (Choose two)

A. FortiAnalyzer provides the ability to create custom reports.

B. FortiAnalyzer glows you to schedule reports to run.

C. FortiAnalyzer includes pre-defined reports only.

D. FortiAnalyzer allows reporting for FortiGate devices only.

Refer to the exhibit.

What does the data point at 14:55 tell you?

A. The received rate is almost at its maximum for this device

B. The sqlplugind daemon is behind in log indexing by two logs

C. Logs are being dropped

D. Raw logs are reaching FortiAnalyzer faster than they can be indexed

What are the operating modes of FortiAnalyzer? (Choose two)

A. Standalone

B. Manager

C. Analyzer

D. Collector

Which FortiAnalyzer feature allows you to retrieve the archived logs matching a specific timeframe from another FortiAnalyzer device?

A. Log upload

B. Indicators of Compromise

C. Log forwarding an aggregation mode

D. Log fetching

Which statements are true regarding securing communications between FortiAnalyzer and FortiGate with SSL? (Choose two.)

A. SSL is the default setting.

B. SSL communications are auto-negotiated between the two devices.

C. SSL can send logs in real-time only.

D. SSL encryption levels are globally set on FortiAnalyzer.

E. FortiAnalyzer encryption level must be equal to, or higher than, FortiGate.

On the RAID management page, the disk status is listed as Initializing.

What does the status Initializing indicate about what the FortiAnalyzer is currently doing?

A. FortiAnalyzer is ensuring that the parity data of a redundant drive is valid

B. FortiAnalyzer is writing data to a newly added hard drive to restore it to an optimal state

C. FortiAnalyzer is writing to all of its hard drives to make the array fault tolerant

D. FortiAnalyzer is functioning normally

You've moved a registered logging device out of one ADOM and into a new ADOM. What happens when you rebuild the new ADOM database?

A. FortiAnalyzer resets the disk quota of the new ADOM to default.

B. FortiAnalyzer migrates archive logs to the new ADOM.

C. FortiAnalyzer migrates analytics logs to the new ADOM.

D. FortiAnalyzer removes logs from the old ADOM.

What can the CLI command # diagnose test application oftpd 3 help you to determine?

A. What devices and IP addresses are connecting to FortiAnalyzer

B. What logs, if any, are reaching FortiAnalyzer

C. What ADOMs are enabled and configured

D. What devices are registered and unregistered

If you upgrade your FortiAnalyzer firmware, what report elements can be affected?

A. Output profiles

B. Report settings

C. Report scheduling

D. Custom datasets

Which statements are true regarding securing communications between FortiAnalyzer and FortiGate with IPsec? (Choose two.)

A. Must configure the FortiAnalyzer end of the tunnel only--the FortiGate end is auto- negotiated.

B. Must establish an IPsec tunnel ID and pre-shared key.

C. IPsec cannot be enabled if SSL is enabled as well.

D. IPsec is only enabled through the CLI on FortiAnalyzer.