CheckPoint 156-836 Exam Questions & Answers

The drop_monitor command is useful for

A. Monitoring Check Point code drops

B. Viewing all interface drops such as RX-ERR, RX-DRP, and RX-OVR

C. Viewing all drops by Check Point code or the Gaia OS, such as RX-DRP, RX-ERR, and Gaia OS drops.

D. Showing the system temperature in real-time for multiple components, such as CPU, fan, and SSDs.

While looking at your system's correction statistics, you notice you have a correction rate approaching 100 percent. Is this a problem?

A. A correction rate above 90 percent indicates a need to disable Layer 4 Distribution.

B. A correction rate approaching 100 percent of all connections is unusual. This is a cause for concern because the SGMs may fail to process traffic.

C. If correction rates are higher than 80 percent, latency is expected.

D. In some scenarios, a correction rate approaching 100 percent of all connections is not unusual. This is not usually a cause for concern as the correction mechanism is fast and efficient.

When security policy is installed

A. All SGMs receive the security policy and one by one performs an independent policy verification. Then, all SGMs simultaneously install the policy.

B. The SMO Master receives the policy and performs a policy verification the policy is installed on the SMO Master, the SMO Master broadcasts the available package, other membersretrieve the new policy from the SMO Master, then the non-SMO Master SGMs install the policy.

C. All SGMs receive the security policy and simultaneous policy installation occurs.

D. The policy is installed on the SMO, the SMO Master broadcasts the available package, other members retrieve the new policy from the SMO Master and perform an independent policy verification, then the non-SMO Master SGMs install the policy.