Cisco 300-615 Exam Questions & Answers

Refer to the exhibit.

A Cisco UCS B-Series Blade Server is configured to boot from a shared storage via an iSCSI network. When a service profile is associated with the blade, the blade fails to attach the LUN. Which action resolves the issue?

A. Place VLAN 0 on the interface that connects to the storage

B. Register the blade as an initiator on the storage array

C. Implement a Layer 3 connection between the blade and the storage

D. Establish a Layer 2 connection between the blade and the storage

Refer to the exhibit.

An engineer must connect N2K-Fex-1 and N5K-Core-1 so that the traffic flow between the two devices uses load balancing. After inspecting the statistics of the interconnecting interfaces, the engineer concludes that only one link is used. Which action resolves the problem?

A. Configure source-destination load balancing on N5K-Core-1.

B. Configure each uplink to be a member of a separate LACP port channel.

C. Configure the pinning max-link as 2.

D. Configure destination-mac load balancing on N5K-Core-1

Refer to the exhibit.

A network engineer must add a Cisco Nexus 5000 Series Switch to a Cisco DCNM. However, the device discovery status shows as unreachable. The engineer verifies these parameters:

1.

compatibility matrix between the DCNM server and the Nexus switch

2.

credentials to the Nexus switch

3.

IP connectivity and reachability between DCNM and the Nexus switch

4.

enablement of SSH on the Nexus switch Which procedure resolves the issue?

A. Restart the Advanced Message Queuing Protocol service in the DCNM appliance.

B. Increase the heap size of the Elasticsearch on the DCNM server.

C. Globally enable Cisco Discovery Protocol on the switch and on the DCNM interface.

D. Rediscover the Nexus switch from the DCNM server.